Nexus WTMW
Dual 8" Three-Way
Dual 8" Three-Way
The Nexus WTMW 3-way was intended as a horizontal center but can also be configured as a vertical WTMW cabinet or as a TMWW tower format. This 3 way design uses two of the Dayton SD215A-88 subwoofer drivers for the the low end.
The design puts the midrange and tweeter in a separate chamber that extends to the top/sides or top/bottom for the center channel layout. The chamber is just deep enough to fit the midrange, 3.75" from the front baffle face to the rear of the chamber (driver flush mounted).
The center channel measures 10" high x 26" wide x 12.5" deep (built from 3/4"). This gives the woofers about 1cuft of volume, they are run sealed and f3 is approximately 58hz. The midrange chamber is 6.5" wide x 3" deep internal and run the height of the cabinet. I run the side panels of that midrange chamber all the way to the back for added bracing and cut some holes in them behind the midrange chamber o allow airflow around the back of the cabinet between the woofers. Driver positions are marked in the 3d cabinet render.
Nexus WTMW Center Cabinet Cutlist:
Overall Cabinet Dimensions - 10"H x 26"W 12.5"D
Baffle/Back (3/4") x2: 10" H x 26" W
Sides (3/4") x2: 8.5" H x 11" W
Top/Bottom (3/4") x2: 26" L x 11" W
Front to Back Braces (3/4") x2: 8.5"H x 11"W - Openings should be added behind midrange chamber)
Mid/High Chamber Back (3/4"): 8.5"H x 6.5"W - This one gets sandwiched between the other two braces to form the sealed midrange chamber.
Crossover Details:
This crossover keeps the simple 2nd order highpass + padding resistor on the tweeter. The midrange uses a simple 1st order highpass at the woofer crossover point, the lowpass is upped to 3rd order to provide the correct shaping needed in the band-pass configuration, R2 is there to help soften the lowpass knee and C3 acts as a tank filter to provide some additional slope to the lowpass and suppress cone breakup. R2 should provide just enough resistance to prevent a purely capacitive load in the ultrasonic region thus the crossover should be safe for Class-D amps as is. The addition of L2/R1 on the woofer lowpass just provide a little more slope and softer knee that helped with the response shape then a purely 2nd order filter would achieve.
Note: Inverted polarity on the midrange and tweeter.
The woofer dual voice coils should be wired in series then the two drivers wired in parallel to the crossover.
Crossover Parts List:
C1 62uF (50uF + 12uF NPE) - C2 15uF (Poly) - C3 0.68uF (Poly) - C4 8.2uF (Poly) - C5 4.3uF (Poly)
L1 5.0mH (18awg I-Core) - L2 0.05mH (20awg Air Core) - L3 1.5mH (20awg Air Core) - L4 0.70mH (20awg Air Core) - L5 0.45mH (20awg Air Core)